High quality M.S. Enclosure.

Working: This model automatically switches ON and OFF the motor.

When the water level of the overhead tank becomes low means water gets down from the middle sensor and water is present in the underground tank or sump, the motor gets started automatically. The tank starts filling up. when the water level reaches to the higher level, the motor automatically gets switched off.

AUTO OFF WHEN TANK IS FULL OR SUMP IS EMPTY.

This model has dry run protection, so it only starts the motor if water is present in the underground tank or sump.

Suitable for 0.1 HP to 5.0 HP Motor, Protect motor from dry running.

Motor ON OFF LED indication provided.

Water Level indication provided for both tanks.

Supply voltage: 220-270 V AC,

Relay: 40 A

Sensing element: S.S sensor, it is free from oxidation, long life. Any conducting wire can be used as a sensor.

All signals pass in sensors through the AC filter circuit that improves the life of sensor,

Auto and Manual mode switch available. In auto mode the motor starts and stops automatically. In manual mode the user can start and stop the motor by pressing the start and stop button of the controller. No additional wiring is required to operate the motor manually. 

Also Suitable for MCB Starter panel and submersible motor, see diagram above for connection.

High quality M.S. enclosure provided.

Fully automatic, controls from underground tank to overhead tank so no manpower required. Long service Life.

Isolated supply provided

Sensor fault detection provided, if sensor got failed LED start blinking

Electrolysis free design